This product has an optimized schematics for 5V and 3.3V MIDI sender devices and optimized circuitry for optocoupler to minimize false triggering and improve sensitivity. Finally it uses hex inverter with a Schmitt trigger for driving a stronger output signal. This makes it very reliable device. This is an active circuit, so it does require an external power. That’s the way it should be according to the MIDI specs.
There are two options for external power:
To be used with a standard wall adapter 6-12V and 5.5mm*2.1mm connector. In this case a Kit comes with corresponding socket and 7805 power regulator
To be powered from USB port. In this case a Kit includes USB->5.5mm*2.5mm cable, corresponding power socket (so you wont plug wall adapter) and doesn't include 7805. Please make sure, you use USB port or adapter with 5V output and verify it prior to connecting to the board. There are some QuickCharge USB chargers which can bump a voltage. Please, avoid using them.
Board size and an enclosure choice: Size: 13x5cm Some of you wondered ideas for enclosure selection. Some kits produced here can be installed into cast cases, such as MidiThru-4 or MidiMerge_2in->5out into 1032L enclosure. It requires drilling and some patience. Other boards are just too big to go into typical aluminum case. We found it much easier to put them in between two acrylic panels cut to the size and connect them with plastic standoffs. I typically use M3 standoff 20mm and 5mm. 20mm goes on top, and has enough room to cover DIN5 sockets, while 5mm goes on the bottom. There is CorelDraw file on Github with precise board dimension and holes location. Another option would be to 3d print the case. Tod Kurt has designed the model and posted it for everybody here.
Please, consider Deftaudio page at Github for additional information.
